PCB BLOG

HDI is actually a kind of PCB technology. HDI, that is high-density interconnection technology. HDI board is the consistent name of Japanese enterprises for high-density interconnection printed circuit board, while in Europe and America, HDI board is called

After 18 years of continuous development, the exhibition was formerly known as

Nowadays, high density interconnect (HDI) printed circuit board is widely used. Traditional HDI circuit board is used in portable products and semiconductor packaging products. This paper will focus on the third type of application of HDI: high-speed industrial system application, which is used in telecommunication and computer systems. The difference between these two types of PCB lies in the large size of PCB, the focus on electrical performance, and the challenge of conductor lies in the very complex packaging of PBGA and CCGA.

With the increasing demand for the volume of information products, especially the development of mobile device products in the direction of continuous miniaturization, such as the current popular ultra book products, even new wearable intelligent devices, must use HDI high-density interconnection technology to make the carrier board, and further reduce the size of the terminal design.

HDI is the abbreviation of the high-density interconnector, it is a kind of technology to produce printed circuit boards. It is a circuit board with high distribution density using micro blind and buried hole technology.

HDI is the abbreviation for high-density interconnector. It refer to a technology for manufacturing printed circuit boards (PCB). Based on traditional multi-layer printed circuit board manufacturing technology, HDI introduces a new process of foil-RCC (Resin Coated Copper) laminate, supplemented by laser drilling, horizontal/vertical PTH (Plated through Hole) wet process and other processes produced by the blind hole/multi-layer buried PCB circuit boards.

printed circuit boards are one of the important electronic components in the electronic industry. Almost every electronic device, from electronic watches, calculators, computers, communication electronic devices, military weapon systems, as long as there are integrated circuits and other electronic components, in order to interconnect them, printed circuit boards are used.

In PCB design, wiring is an important step to complete product design. It can be said that the preparation work is done for it. In the whole PCB, the design process of wiring is the highest, the skills are the finest and the workload is the largest.

The layout should strive to meet the following requirements: keep the overall wiring as short as possible, with the shortest possible routing for critical signal lines; separate high-voltage, high-current signals from low-current, low-voltage weak signals; separate analog signals from digital signals; separate high-frequency signals from low-frequency signals; and ensure sufficient spacing between high-frequency components.

​When PCB makers make PCB files, we often need to add break-up tab on the unit board or panel. This paper describes the design specifications of common break-up tab.In the process of PCB design, for some reasons, the distance between the edge of components and the long edge of PCB is less than 5 mm. In order to ensure the efficiency and quality of PCB assembly, the designer should add the break-up tab to the corresponding long edge of PCB.

Because copper is easy to oxidize in air, the oxide layer of copper has a great influence on soldering. It is easy to form false welding and false welding. In serious cases, it will cause the pad and components cannot be welded. Therefore, PCB will have a process in manufacturing, coating (plating) on the pad surface to protect the pad from being oxidized.

Broad sense: printed circuit boards are equipped with resistors, capacitors, IC and other electronic components, and the products are electrically connected by soldering. Generally we also call it as PCBA.